This!

Yay for ColorInput and TelInput

Love that series!

Nice technique. I have previously only seen it with laser cut wood, why not for 3d printing?!

Continue! Chaque fournée te rends plus près du pain de tes rêves :)

Nice technique I had never heard of!

One of my first movies and I’ll never forget that adventure. I have no question though.

I beg to disagree about the disadvantages. An important one is that you cannot easily update shared libraries globally. This is a problem with things like libssl or similar. Another disadvantage is the added complexity both wrt. to operation but also in general the amount of code running. It can also be problematic that many people just run containers without doing any auditing. In general containers are pretty opaque compared to os packaged software which is usually compiled individually for the os.

This being said, systemd offers a lot of isolation features that allows similar isolation to containers but without having to deal with docker.

Thanks for that list. I have AllPHA. Will try it out soon. Is it very hydrophilic?

Yes, we had a guided tour for a work related event hosted by Meise.

Very interesting. Thanks! I wonder if it could be used as an axis in a 3d printer

Not a big fan of Bezos though.

What brand do you use? Where do you buy? On what continent are you sitting?

It’s a good idea but I’m sceptical about anything friction to hold the darts. The problem is that they have very sharp machined rings that make them very non-slippery to the fingers. I’m pretty sure those rings would file off anything they slide against very quickly.

The steel tip does not have this problem though, so adding some part that pushes against the tip might be the solution. Alternatively, i could also make the part that houses the flights be somehow spring loaded and squeeze them.

Man, I love PHA, at least the idea of it. I have an unopened roll of it lying around because I’m afraid to waste it. I’ll give it a go on my next print. It’s unfortunate that it’s still hard to find and a bit expensive. All hail PHA!

Yeah, I think I see what you mean. I’m very plastic conservative so I hope I can go without printing a second one, therefore the clip idea. Also the clip is a bit more practical better looking.

They fall out. For now I use a rubber band around the case but I don’t like that solution too much. The initial idea was to put a rubber band around the “waist” so that they would be held there. Unfortunately the rubber then doesn’t touch the dart. My current idea for a fix is to make a clip that pushes against that darts sideways through the holes.

This is fantastic! I have half assed plans of a similar design in FreeCAD lying around. I haven’t come around building it yet. I’ll surely take some inspiration here.

Thanks for the tip. The BME280 are also not too bad.

I’ve had massive differences in readouts in DHT22 from aliexpress. They are really not good sometimes